Honeywell MeshGuard FTD-2000 User Manual

MeshGuard User’s Guide
42
Next, place the MeshGuard into the enclosure:
1. Lift up the hinged cover of the enclosure.
2. Slide the MeshGuard into the enclosure from the top.
3. Close the cover of the enclosure.
4. Insert the hex screw into the cover’s locking portion, and tighten it.
5. The MeshGuard is now ready to use.
Note: The sensor cover on the bottom of the enclosure can be removed so that the filter and sensor can be
inspected without removing the MeshGuard from the enclosure. Simply pull off the cover and follow the
maintenance procedures in this guide.
1
2
5
4
3

Honeywell MeshGuard FTD-2000 Specifications

General

Brand	Honeywell
Model	MeshGuard FTD-2000
Category	Monitor
Language	English