7–6
Data Transmission Delays
Use these codes to select the amount of delay between sending data
characters from the scanner to the host. This helps prevent the scanner from
overflowing host-input buffers.
* 1 msec Intercharacter Delay
10 msec Intercharacter Delay
25 msec Intercharacter Delay
~ Variable msec Intercharacter Delay – Scan this
bar code and a sequence of code bytes on page
16–1 to set the delay between characters sent to
the host system (range from 1 to 255 msecs.).
~ Variable Inter-Record Delay
Turn Off Laser During Inter-Record Delay
* Leave Laser On During Inter-Record Delay
To Next Page
Loading...
Need help?
General
