Alarm mode
There are two selectable alarm types:
Latched When the alarm is triggered, you can manually stop the alarm.
The latched setting only controls alarms for High Alarm, Low Alarm, STEL Alarm, and TWA
alarm.
Note: To clear an alarm when the instrument is set to “Latched,” press [Y/+] when the main
(Reading) display is shown. Take into account that the pump alarm is always latched.
Automatic Reset When the alarm condition is no longer present, the alarm stops and resets
itself.
1. Press [N/-] to step from one alarm type to the other.
2. Press [Y/+] to select an alarm type.
When you have completed your selections, press [MODE].
You will see two choices: Save and Undo. You have the opportunity to register the new settings
or to change your mind and revert to your previous settings.
l
Press [Y/+] to save the changes.
l
Press [N/-] to undo the changes and revert to the previous settings.
Buzzer & light
The buzzer and light alarms can be programmed to be on or off individually or in combination.
Your choices are:
l
Both on
l
Light only
l
Buzzer only
l
Both off
1. Press [N/-] to step from one option to the next.
2. Press [Y/+] to make your selection (the dark circle in the “radio button” indicates your
selection).
3. When you have completed your selections, press [MODE].
You will see two choices: Save and Undo. You have the opportunity to register the new settings
or to change your mind and revert to your previous settings.
l
Press [Y/+] to save the changes.
l
Press [N/-] to undo the changes and revert to the previous settings.
Handheld PID Monitors 81 User Manual
To Next Page
Loading...
