Datalog
The instrument calculates and stores the concentration and ID of each sample taken. In the
datalog sub-menu, a user can perform the tasks and functions shown below.
MiniRAE 3000+, ppbRAE 3000+, UltraRAE MiniRAE Lite+
1. Scroll through the Datalog sub-menu using the [N/-] key until the display shows the
desired parameter to be changed:
Clear Datalog
Interval
Data Selection
Datalog Type
2. Press [Y/+] to make your selection. Exit by pressing [MODE] for Back.
Clear datalog
This erases all the data stored in the datalog.
Note: Once the datalog is cleared, the data cannot be recovered.
Press [Y/+] to clear the datalog. The display asks, “Are you sure?”
l
Press [Y/+] if you want to clear the datalog. When it has been cleared, the display shows
“Datalog Cleared!”
l
Press [N/-] if you do not want to clear the datalog.
The display changes, and you are taken to the next sub-menu, Interval.
Handheld PID Monitors 82 User Manual
To Next Page
Loading...
