Programming mode menus
The Programming Mode allows anyone with the password to change the instrument’s settings,
calibrate the instrument, modify the sensor configuration, enter user information, etc.
Programming Mode has five menus. Each menu includes several sub-menus to perform
additional programming functions.
The table on the next shows the menus and sub-menus.
All entries are supported on MiniRAE 3000+, ppbRAE 3000+, and UltraRAE 3000+.
Entries marked with an asterisk ( * ) are supported on MiniRAE Lite+.
Note: If the instrument is non-wireless the options will be crossed out.
Calibration Measurement Alarm Setting Datalog Monitor Setup
Zero Calibration * Meas. Gas High Alarm * Clear Datalog * Radio Power*
Span Calibration
*
Meas. Unit Low Alarm * Interval * Op Mode
Bump * Tube Selection STEL Alarm
Data Selection
*
Site ID
TWA Alarm Datalog Type * User ID
Alarm Mode * User Mode
Buzzer & Light
*
Date *
Time *
Pump Duty Cycle
Pump Speed
Temperature Unit
Language *
Power On Zero*
Real Time
Protocol*
Unit ID
Lamp ID
PAN ID*
Handheld PID Monitors 71 User Manual
To Next Page
Loading...
