Mesh interval
Set the time interval at which the instrument’s mesh radio sends out a signal. This can range
from once every 10 seconds to once every four minutes (240 seconds). The transmission
frequency is user-adjustable, but a rate of at least once every 30 seconds is recommended.
Note: Shorter intervals reduce battery life.
1. Press [N/-] to step from one option to the next.
2. Press [Y/+] to make a selection.
3. When you are done, press [MODE].
Note: Mesh Interval only applies to instruments equipped with a MESH Radio Modem, not BLE
or BT.
Handheld PID Monitors 92 User Manual
To Next Page
Loading...
