7
INSTALLATION NOTES FOR USB INTERFACE
Metrologic’s MX009 USB cable is a device that converts serial RS232
formatted data to either USB Keyboard or USB Point-of Sale
communication protocol.
Please refer to the MX009 USB Converter Cable Programming Guide
(
MLPN 00-02574A) supplied with your MX009 cable for detailed
installation and programming guidelines.
INSTALLATION NOTES FOR MS7120-00 LASER EMULATION
MS7120-00 Only
The MS7120-00 leaves the factory with the Laser Emulation Mode
enabled. If you recall defaults while re-configuring your scanner the Laser
Emulation Mode will no longer be enabled.
Scan the following barcode to re-enable the Laser Emulation interface.
The scanner you are using must be labeled as an MS7120-00 to support
this feature.
Enable Laser Emulation Mode
³999979
To Next Page
Loading...
