Honeywell NOTIFIER INSPIRE E10 - Enable; Disable Zones

20
Enable / Disable Zones
ENABLE / DISABLE ZONES
You can selectively disable or enable Zone(s) using the
‘Group by: Zones’ view. Also you can enable or disable
System Functions from this view.
Enable/Disable
Enable / disable Devices, Zones
etc








If disabled, the
Display shows:
DISABLE
LED indication
given:
1 Point
Points
20 Points
5 Points
16 Points
Points
Points
7 Points
15 Points
17 Points
27 Points
Control Outputs
How to Enable / Disable Zone(s)
01 Select the Menu icon  and log in with your
Access level 2 password.
02 Select the ‘Enable/Disable’  button and
ensure ‘Group By: Zone’  is selected from
drop down options.
03 Momentarily select the required Zone check
box(s)  ensure the required boxes are
checked ..
04 Select either ‘Permanently Disable’ or
‘Enable’  button. Note the selected Zone(s)
are either disabled or enabled.
How to Enable/Disable System Functions
05 Carry out steps as for How to Enable /
Disable Zone(s), steps 01 to 02. Expand the
'System Functions' view .
06 If installed and configured you can now
select either ‘Disable’ or ‘Enable’  the
required 'System Function':
- Alarm Devices
- Fire Alarm Routing Equipment
- Fire Protection Equipment
- Fault Routing Equipment
- Control Outputs.
An indication is given if disabled.