Honeywell NOTIFIER INSPIRE E10 - Enable; Disable Devices on a Loop

22
Enable / Disable Devices on a Loop
ENABLE / DISABLE DEVICES ON A LOOP
You can selectively disable or enable Device(s) on a Loop
and disable or enable System Functions.
Enable/Disable
Enable / disable Devices, Zones
etc







If disabled, the
Display shows:
DISABLE
LED indication
given:
P01 - Panel 1
L01 - Loop 1
D001 - Device 1 or
M001 - Module 1
Control Outputs
How to Enable / Disable Device(s)
01 Select the Menu icon  and og in with your
Access level 2 password.
02 Select the ‘Enable/Disable’ button  and
ensure ‘Group By: Loops’  is selected from
drop down options.
03 Momentarily select the required Device
check box  to toggle and ensure it is
checked . You can select multiple Device
check boxes.
04 Select either ‘Permanently Disable’ or
‘Enable’  button. Note the selected Device(s)
are either disabled or enabled. The DISABLE LED
is lit or unlit depending on the selection made.
Enable / Disable System Functions
05 Carry out steps as for Enable / Disable
Device(s), steps 01 and 02. Expand the view
'System Functions' .
06 If installed and configured you can now
‘Disable’ or ‘Enable’  the required 'System
Functions':
- Alarm Devices.
- Fire Alarm Routing Equipment,
- Fire Protection Equipment
- Fault Routing Equipment
- Control Outputs
An indication is given if disabled.