Honeywell NOTIFIER INSPIRE E10 - LED Indicators and PUSH Button Controls

5
INSPIRE E10/E15 Control Panels - Operating instructions
LED INDICATORS AND PUSH BUTTON CONTROLS
There are 7 status LED indicators provided on the panel fascia and there are 3 push buttons for event conditions.
Condition /
Control
LED
Colour
Description
FIRE
FAULTFAULT
SYSTEM FAULT
DISABLE
DELAY ACTIVE
POWER
SILENCE-RESOUND
MUTE BUZZER
RESET
TEST
FIRE Red
A fire condition has been detected.
FAULT Yellow
There is a fault in the system.
SYSTEM FAULT Yellow
The system software or parts of it has failed
and/or the site specific data is corrupt.
DISABLE Yellow
One or more device / zone are disabled.
TEST Yellow
A system test is in progress.
DELAY ACTIVE Yellow
One or more sounder / output delay is
configured in the Cause & Effect matrix.
POWER Green
The system is switched On and the power is
supplied via the mains voltage.
The essential controls are the push buttons and touch screen buttons, when lit
they are active for selection by the authorised users having password access to the
controls The buttons are made active during event conditions, such as after fire
detection or when a fault has occurred in the system.
SILENCE/
RESOUND
White
Silence or Resound the alarms sounders and
outputs in the system.
MUTE BUZZER White
Silence the panel buzzer.
RESET White
Reset the panel after a fire condition.