5. Operation
5.1. Overview
Revision 3 OneWireless XYR 6000 ISA100.11a Compliant Pressure Transmitter User's Manual 17
March 2012
5. Operation
5.1 Overview
Display modes
The transmitter has the following display modes.
Test. Appears briefly after power-up
t
o self-test the display.
Connection status. Appears when transmitter is not fully connected to the OneWireless network. See
section 5.2.
PV display. Default mode of the transmitter displays the PV and any status messages. See section 5.3
on page 19.
Quick view of transmitter identification parameters. Displays read-only parameters then returns to PV
display. See section 5.4 on page 25.
Menu. See section 5.5 on page 26.
Provisioning Device
To navigate the transmitter displays and menus, hold the Provisioning Device no more than 6” from the
transmitter and aim the infrared beam at the transmitter display while tapping the Device Local
Configuration buttons (Table 5-9).
Prov
isioning Device menus are described in section 5.6 starting on page 27.
To Next Page
Loading...
