Revision 3
OneWireless XYR 6000 ISA100.11a Compliant Pressure Transmitter User's Manual iii
March 2012
About This Document
This document describes preparation, operation and maintenance of the XYR 6000 Wireless Pressure Transmitters.
Mounting, installation and wiring are covered in other documents.
Honeywell does not recommend using devices for critical control where there is a single point of failure or where
single points of failure result in unsafe conditions. OneWireless is targeted at open loop control, supervisory
control, and controls that do not have environmental or safety consequences. As with any process control solution,
the end-user must weigh the risks and benefits to determine if the products used are the right match for the
application based on security, safety, and performance. Additionally, it is up to the end-user to ensure that the
control strategy sheds to a safe operating condition if any crucial segment of the control solution fails.
Revision Information
Document Name
XYR 6000 ISA100.11a Compliant Pressure
Transmitter User's Manual
Document ID Revision
Number
Publication Date
New 34-XY-25-43 1 January 2011
ISA 100 34-XY-25-43 2 October 2011
Added Flange Mount and Remote Seal data,
updated Approvals information
34-XY-25-43 3 March 2012
References
The following list identifies all documents that may be sources of reference for material discussed in this publication.
Document Title
XYR 6000 Transmitters Quick Start Guide 34-XY-25-21
Getting Started with Honeywell OneWireless Solutions OW-CDX010
OneWireless User’s Guide OW-CDX060
OneWireless Builder Parameter Reference OW-CDX070
To Next Page
Loading...
