32 www.honeywell.com
SNET reader types require various settings, depending on the SNET reader type that is
being used. You can configure these settings at the logical device or you can
pre-configure them in the hardware templates. The advantage of using the hardware
template is that the configured settings are applied each time that a new logical device
is created, so it saves time when these are configured with the settings that you want to
use.
To configure the settings in the hardware template:
1. Go to
Hardware Configuration.
2. Select
Hardware Templates.
3. Double-click the appropriate template.
4. Select the tab
Device Types.
5. Double-click on
Reader.
6. Select the tab
PW-5000/6000 Reader.
Figure 15: Hardware Configuration Settings
To Next Page
Loading...
