PW6K1ICE Introduction
Alarm Management
PW6K1ICE Installation and Configuration Guide, Document 800-07985V1, Revision A 5
1.7 Alarm Management
• Normally open/Normally closed, unsupervised, supervised.
• Standard or custom end-of-line resistances.
1.8 Warranty
Honeywell Security Access warrants that the product is free from defects in material
and workmanship under normal use and service with proper maintenance for one year
from the date of factory shipment.
Honeywell Security Access assumes no responsibility for products damaged by
improper handling or installation. This warranty is limited to the repair or replacement
of the defective unit.
There are no expressed warranties other than set forth herein. Honeywell Security
Access does not make, nor intends, nor does it authorize any agent or representative to
make any other warranties, or implied warranties, and expressly excludes and
disclaims all implied warranties of merchantability or fitness for a particular purpose.
Returned units are repaired or replaced from a stock of reconditioned units. Returns
must be accompanied by a Returned Merchandise Authorization number (RMA)
obtained from customer service, and prepaid postage and insurance.
1.9 Liability
The Interface should only be used to control exits from areas where an alternative
method for exit is available.
This product is not intended for, nor is rated for operation in life-critical control
applications.
Honeywell Security Access is not liable under any circumstances for loss or damage
caused by or partially caused by the misapplication or malfunction of the product.
Honeywell Security Access's liability does not extend beyond the purchase price of
the product.
1.10 FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
To Next Page
Loading...
