PX940 User Guide 15
Note: There is a media guide that is located near the printhead. It is recommended to adjust
the media guide all the way to the right in order to insert the media. If not, it can be
difficult to load the media.
7. Adjust the label gap and black mark sensor. The sensor blue LED should line
up with the center of the media.
8. Turn the printhead lift lever clockwise to close the printhead and lower the
front arm and click into place.
front arm in place (PX940A) front arm in place (PX940V)
9. Press the Print button to advance the media.
10. Close the media cover.
To Next Page
Loading...
