42 PX940 User Guide
Webpage
The supported features are listed as the following:
• Verification configurations
• Verification statistics
• Restore default verification database and failed label image files
• Verification reports for download
Front Panel
The supported features are listed as the following:
• Verifier Calibration Wizard
• Verification Results Display Wizard - Allow the user to browse through all the
barcodes detailed result in the last label printed.
USB menu to export all verification reports and saved label image file.
Calibration
Calibrating the verifier maintains the accuracy of the verifier when scanning an
image. Calibration is performed prior to the shipment of the printer.
Note: Honeywell recommends calibrating the verifier every six months for maximum
performance.
Verifier Calibration Card
The calibration card is used to calibrate the verifier. It is very important to follow the
instructions on the calibration card packaging for proper care of the calibration
card. If you lose your calibration card, visit www.honeywellaidc.com and navigate to
the PX940 printer product page.
Handling Instructions
• When not in use, keep the calibration card inside its original packaging, away
from direct light exposure and stored at room temperature
• Keep calibration card clean.
• Use a dry cloth to remove any dirt if needed.
• Do not bend the card
• Do not perform verifier calibration if the card is damaged.
Note: DO NOT touch the section of the calibration card that is enclosed in the red box as
shown below.
To Next Page
Loading...
