44 PX940 User Guide
Verifier Settings
This section gives a brief description of the verifier settings.
Verification Type
Select the verification type to check the barcode.
• None - No barcode validation
• Read/No Read - Validate if barcode is readable
• ISO15415/15416 - Full ANSI grading of barcode
Passing Grade
Sets the minimum passing grade for barcode grading. Grade 0.0 (F) is the lowest
grade. Grade 1.5 (C) is the default and recommended by ISO standard. Only
applied when verification type is set to ISO15415/15416.
Aperture
Indicates the aperture size in mils (1000 mils = 25.4mm) used for verification.
Aperture size will be chosen automatically based on ISO standard. Change only if
required by an overriding application.
Maximum Consecutive Failures
Sets maximum number of times printer encountered verification failure consecu-
tively before prompting for user action. This setting is only applicable when the
Verification Failure Action is set to Void and Reprint.
Verification Failure Action
Indicates action to take when label fails verification.
• Void and Reprint (default) - Retract and void the failed label, then reprint the
failed label. Stop reprint if the maximum consecutive failures have been
reached.
• Ignore and Continue - No voiding when verification fails. Result is saved and
next label is printed.
Note: Note: During multiple label printing, printer will void the failed label (plus all printed
and yet to be verified labels) in order to keep the good labels in sequence.
Save Failed Label Images
When enabled, the printer saves all failed label images in non-volatile memory.
Maximum 100 images can be saved (if memory available). At maximum capacity
oldest image file will be replaced by newest.
To Next Page
Loading...
