Honeywell ScanPal EDA10A User Manual

EDA10A Enterprise Tablet User Guide 7
• Power off the computer.
• Place the unit in Swap Battery mode (see below).
Hot Swap
You can replace the battery on demand provided the following conditions are met:
• The tablet has been powered on for at least 4 minutes.
AND
• You insert a new battery within 30 seconds.
Replace the Battery
Remove the Battery
1. Either power off the computer or place it in battery swap mode. See Before
Attempting to Remove the Battery on page 6.
2. Release the hand strap, if applicable.
3. Pull the battery cover up at the notch then remove the battery cover from the
unit.
4. Slide the battery release latches to unlock the battery.
DRAFT - 3/24/23

Honeywell ScanPal EDA10A Specifications

General

Brand	Honeywell
Model	ScanPal EDA10A
Category	Tablet
Language	English