EDA10A Enterprise Tablet User Guide 41
Before you start scanning barcodes, go into Settings > Honeywell Settings >
Scanning > Internal Scanner and modify the scan profile to enable only the
barcode symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
Note: To use the rear scan button, navigate to Settings > Honeywell Settings > Touch Key
and turn on Touch Key Switch.
1. Point the scanner window at the barcode. For optimum performance, avoid
reflections by scanning the barcode at a slight angle.
2. Press and hold the right, left, or rear scan button.
3. Center the aiming beam over the barcode. Make sure the entire barcode is
inside the illumination frame.
4. Release the button when the computer beeps. The barcode information is
entered into the application in use.
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
About Scanning Configuration Barcodes
After completing the out-of-box set up process, Provisioning mode is
automatically turned Off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you turn On
(enable) Provisioning mode in the Settings app.
To learn more About Provisioning Mode see page 74.
To Next Page
Loading...
