116 Solaris 7980g User Guide
UPC-E0 Expand
UPC-E Expand expands the UPC-E code to the 12 digit, UPC-A format.
Default = Off.
UPC-E0 Addenda Required
When Required is scanned, the scanner will only read UPC-E bar codes that have
addenda. Default = Not Required.
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for UPC-E0 Addenda Required. Set the length
(in milliseconds) for this timeout by scanning the bar code below, then setting the
timeout (from 0-120 milliseconds) by scanning digits from the Programming
Chart, beginning on page 235 of this manual, then Save. Default = 500.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
To Next Page
Loading...
