120 Solaris 7980g User Guide
EAN/JAN-13 Addenda
This selection adds 2 or 5 digits to the end of all scanned EAN/JAN-13 data.
Default = Off for both 2 Digit and 5 Digit Addenda.
EAN/JAN-13 Addenda Required
When Required is scanned, the scanner will only read EAN/JAN-13 bar codes that
have addenda. Default = Not Required.
EAN-13 Beginning with 290 Addenda Required
This setting programs the scanner to require a 5 digit addenda on EAN-13 bar
codes that begin with “290.” The following settings can be programmed:
Require 5 Digit Addenda: All EAN-13 bar codes that begin with a “290” must have
a 5 digit addendum. The EAN-13 bar code with the 5 digit addendum is then trans-
mitted as a single, concatenated bar code. If a 5 digit addendum is not found
within the Addenda Timeout period, the EAN-13 bar code is discarded.