124 Solaris 7980g User Guide
Don’t Require 5 Digit Addenda: If you have selected Require 5 Digit Addenda, and
you want to disable this feature, scan Don’t Require 5 Digit Addenda. EAN-13 bar
codes are transmitted, depending on the setting you are using for EAN/JAN-13
Addenda Required.
Default = Don’t Require 5 Digit Addenda.
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for EAN/JAN-13 Addenda Required. Set the
length (in milliseconds) for this timeout by scanning the bar code below, then set-
ting the timeout (from 0-120 milliseconds) by scanning digits from the
Programming Chart, beginning on page 235 of this manual, then Save. Default =
500.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
EAN/JAN-13 Addenda Separator
When this feature is On, there is a space between the data from the bar code and
the data from the addenda. When turned Off, there is no space. Default = On.
Note: If you want to enable or disable EAN13 with Extended Coupon Code, refer to UPC-A/
EAN-13 with Extended Coupon Code (page 114).
* Don’t Require 5 Digit Addenda