CHAPTER
3
31-00400M-01 | Rev10-20 23
Initial Configuration
Prerequisites
Before going through initial guided setup sequences, ensure the TC500A is installed
and wired up according to the TC500A installation and mounting guide.
After installing the thermostat and powering it up, user will be guided through the
first-run process. Complete these steps to configure the thermostat and connect
Online. The Setup Assistant guide you through the process including:
• Setting a display language
• Specifying a name to the thermostat
• Selecting temperature measurement units
• Selecting an equipment type and setting up the details
• Setting an administrator password
• Setting up a network connection and choosing the network connection type
WARNINGS
• To reduce the risk of electrical shock do not open the thermostat. There are no
user serviceable parts inside. Refer servicing to a qualified service personnel only.
• Cleaning — Use a dry cloth to clean the product. Do not use liquid cleaners or
aerosol cleaners
• Water and moisture — Do not use the product near water. Do not install the
product in a place where water may splash onto it.
• Do not operate the thermostat with a hard, sharp or pointed object such as a
fingernail, pen.
• The screen used of the thermostat is made of glass. Therefore, it can break when
the product is dropped or heavy impact is applied. Be careful not to be injured by
broken glass pieces in case the screen breaks.
To Next Page
Loading...
Need help?
General
