CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
63-4528—04 152
• When the VFD runs after Pr.02-30 delay time, the corresponding multi-function output terminal (12: mechanical brake release)
will be ON. It is recommended to use this function with DC brake.
• If this parameter is applied without DC brake, it will be invalid. Refer to the following operation timing.
02 - 30 Brake Delay Time
Factory Setting: 0.000
Settings 0.000~65.000 seconds
TIME
STOP
07-02
DC BRAKE TIME
DURING
START-UP
07-03
DC BRAKE TIME
DURING
STOPPING
BRAKEDBRAKED
B A
A
FREQUENCY
COMMAND
OUTPUT
FREQUENCY
RUN / STOP
MECHANICAL BRAKE
MULTI-FUNCTIONAL
OUTPUT (MECHANICAL
BRAKE RELEASE)
PR.02- 11 TO 02-14 12
M33641
RUN
RELEASE
DC BRAKE
DC BRAKE
BOUNCE TIME OF
MECHANICAL BRAKE
02- 30 BRAKE
DELAY TIME
TIME
STOP
BRAKE
BRAKE
ZERO
SPEED
ZERO
SPEED
B A
A
FREQUENCY
COMMAND
OUTPUT
FREQUENCY
RUN / STOP
MECHANICAL BRAKE
MULTI-FUNCTIONAL OUTPUT
(MECHANICAL BRAKE RELEASE)
PR.02- 11 TO 02-14 12
M33642
RUN
RELEASE
To Next Page
Loading...
