DescriptionPart Number in Diagram
rubber stop for leveling charger against wall2
locking arm for securing charger to DIN rail3
mounting hook for hanging charger on DIN rail4
USB port for charger software upgrades (only on battery charger)5
Mounting the A700 Device or Battery Charger
You will need:
• DIN rail, slotted steel 35 mm X 15 mm, Vocollect Part #CM-1000-20-101 or customer-supplied DIN rail
meeting the following specifications
Standard DIN railDIN rail specsMinimum cut
lengths for rail
Number of
chargers on rail
Single unit length 550 mm; weight
331.5 g (11.6933 oz)
550 mm1
1101 mm2
1652 mm3
• Drill
• Fasteners
• Screw driver
1.
Install the DIN rail on the wall in the desired location. Ensure that the secure installation, supporting surface,
and mounting hardware will safely support the weight of a fully loaded charger, at 25 lbs. per linear foot
(37.2 kg/m) of DIN rail. Ensure that the anchor holes are at least 12 inches (30.5 cm.) from the floor. Verify
that the installation meets all local building codes.
2.
Important: The power supply for the charger should already be zip-tied in the back of the charger
chassis. If it is not, plug the power supply into the charger and secure it. Do not plug it into a power
source until after mounting is complete.
Before attaching the charger to the rail, open the locking arms on the back of the unit by rotating the two
levers out on each side of the charger. The arms are parallel to the floor in the unlocked position.
3.
Attach the charger to the DIN rail by hanging the two hooks on the back of the unit on the top lip of the
rail.
4.
Slide the charger horizontally to the desired position on the rail, and rotate the locking arms into the locked
position - flush with both sides of the unit.
5.
If the charger does not feel secure on the rail, adjust the rubber stops on the back of the unit by screwing
them out toward the wall.
6.
Plug the power supply into a power source and check the LED indicator at the bottom right of the charger
face. If the indicator light is a solid green, the charger is powered on.
Confidential: For informational use by Honeywell resellers and customers only
Chargers | 33
To Next Page
Loading...
