Honeywell Vocollect Talkman A700 - SRX2 and A700 Battery Charger LED Indicators

SRX2 and A700 Battery Charger LED Indicators
The SRX2 battery charger and the A700 battery charger have an LED indicator light, located at the bottom
right of the charger face, that signals the status of the charger.
• Solid green LED: Charger power is on
• No light: Charger power is off
• Solid red LED: Charger is experiencing a power fault (SRX2 only)
Note: If the charger LED indicator is red, unplug the charger power supply from the power source,
and remove all batteries. Plug the power supply into the power source again. If the LED remains red,
the charger may require repair or replacement.
Charger Port Indicators
Additionally, each battery port has two LED indicator lights that apply to the status of the resident battery.
• The ring LED is a circular light that indicates the battery's charge status.
• The alert LED, in the shape of an exclamation point (!), indicates that there is a battery condition requiring
attention. When this indicator is on, the battery on that charger port may not last a full shift. Check
VoiceConsole for a specific alert message.
Figure 9: Battery Port Indicators
The following chart describes the patterns for the battery port LED indicator lights.
SRX2 Battery StatusAlert LED (Battery
Health)
Ring LED (Charge
Status)
Battery is fully chargedOffSolid Green
Battery is chargingOffSolid Yellow
Charging fault detectedOffBlinking Red
Battery alert condition; fully chargedSolid RedSolid Green
Battery alert condition; chargingSolid RedSolid Yellow
Battery alert condition; fault detectedSolid RedBlinking Red
Confidential: For informational use by Honeywell resellers and customers only
34 | Vocollect Talkman A700 Product Guide