Honeywell Vocollect Talkman A700

To Next Page

To Previous Page

DescriptionDefault ValueRegistry Key

Disable transmission of AIM identifier.0x0CompositeUnconventional

A single character inserted before the barcode data to

indicate the symbology.

0x2aCompositeCodeMarkCC-AB

A single character inserted before the barcode data to

indicate the symbology.

0x2aCompositeCodeMarkCC-C

Decode mode for EAN/UPC composites, where 0 = never

linked (only EAN/UPC transmitted), 1 = always linked (2D

component required), and 2 = autodiscriminate.

0x2UPCAndEANCompositeMessageDecoding

User-defined symbology identifier. Range is 0-4 characters."G0"CompositeABUDSI

User-defined symbology identifier. Range is 0-4 characters.TODOCompositeCUDSI

[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\Multicode] - Multiple Symbology Concatenation Support

Activates the ability to read multiple barcodes with one

trigger press. If this value is set to 1 (enabled), then

0x0MulticodeActivation

barcodes that don't match the masking criteria can be

returned independently of other barcodes (normal

operation). If this value is set to 2 (exclusive), then barcodes

that don't match the masking criteria will be discarded.

Number of barcodes in the multicode. Range is 2-8.0x2MulticodeNumberOfBarcodes

Enables transmission of incomplete multicode after the

timeout is reached.

0x0MulticodeIncompleteTransmission

A single character inserted before the barcode data to

indicate the symbology.

0x2aMulticodeCodeMark

A single character inserted before the barcode data to

indicate the symbology. Used when incomplete transmission

is enabled and the timeout is reached.

0x2aMulticodeCodeMarkOfIncomplete

Intermec-specific symbology identifier (0x0 is disabled).0x0MulticodeIDForBarcode1