Honeywell Xenon XP 1950g - Page 106

88 Xenon XP User Guide
Trigger Number
This sets the number of trigger presses required to activate the Trigger Toggle
Mode.
Trigger Timing
This sets the timing of the trigger presses in order to qualify as a trigger toggle,
rather than a regular trigger press. After scanning the Trigger Timing barcode, set
the time-out duration (from 50-2,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 311, then Save. Default = 400ms.
Trigger Toggle Timeout
This sets the length of time the scanner stays in trigger toggle mode before
reverting to scan mode. After scanning the Trigger Toggle Timeout barcode, set
the time-out duration (from 0 to 65 seconds) by scanning digits from the
Programming Chart, beginning on page 311, then Save. Default = 5 seconds.
Note: If this is set to 0, you must repeat the toggle sequence to return to the default
scanning mode. For example, if 2 quick trigger presses puts the scanner into
centering mode and the Trigger Timing is 0, you would have to do 2 quick presses
again to go back to the default scanning mode.
2 Quick Triggers
3 Quick Triggers
4 Quick Triggers
Trigger Timing
Trigger Toggle Timeout