54 Xenon XP User Guide
Page
Page Mode
By default, the page button on the base or Access Point pages the scanners
associated with that base or Access Point. If you want the page button on your base
or Access Point to be disabled, scan the Page Mode Off barcode, below. When
Page Mode is off, the base or Access Point will no longer page scanners when the
button is pressed. The red LED on the base or blue LED on the Access Point will
remain lit to indicate that page mode is off. (This light will go out when the button is
pressed, then back on when it’s released.) Default = Page Mode On.
Note: If you are using a Xenon XP 1952h model, refer to Quiet Operations - LED and
Volume Settings on page 119 for additional Page Button settings.
Page Pitch
When you press the page button on the base or Access Point, the scanners
associated with that base or Access Point will begin beeping (see Page Button on
page 45). You can set the pitch of the paging beep for each scanner by scanning
one of the following barcodes. Default = Low.
* External or Interface
Cable Power
To Next Page
Loading...
