Xenon XP User Guide 45
Page Button
When you press the page button on the base or Access Point, the scanners
associated with that base or Access Point will begin beeping (3 short and 1 long
beep). If you press the trigger on a scanner that is beeping in response, or press the
page button on the base or Access Point a second time, all associated scanners will
stop beeping. See Page on page 54 for further information about page button
settings.
Note: If you are using a Xenon XP 1950h model, refer to Quiet Operations - LED and
Volume Settings on page 119 for additional Page Button settings.
Page Button and Presentation Modes
When in Streaming Presentation Mode, the scanner’s aimer goes out after a short
time, but the scan illumination remains on all the time to continuously search for
barcodes (see Streaming Presentation™ Mode on page 94). When in Temporary
Streaming Presentation Mode, pressing the page button on the base puts the
scanner into Streaming Presentation Mode until the timeout occurs. If a barcode is
scanned before the timeout is reached, the timer starts over.
When the scanner is in the base, press the page button once to put the scanner
into Temporary Streaming Presentation Mode. When the scanner is in the base and
the base has external power (plugged into an outlet), press the page button twice
to put the scanner into Streaming Presentation Mode. Press it twice again to end
Streaming Presentation Mode. When the base does not have external power,
pressing the page button twice does not trigger Streaming Presentation Mode.
To Next Page
Loading...
