164 Xenon XP User Guide
Straight 2 of 5 IATA (two-bar start/stop)
<Default All Straight 2 of 5 IATA Settings>
Straight 2 of 5 IATA On/Off
Straight 2 of 5 IATA Redundancy
If you are encountering errors when reading Straight 2 of 5 IATA barcodes, you may
want to adjust the redundancy count. Redundancy adjusts the number of times a
barcode is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the
barcode. To adjust the redundancy, scan the Straight 2 of 5 IATA Redundancy
barcode below, then scan a redundancy count between 0 and 10 on the
Programming Chart, beginning on page 311. Then scan the Save barcode. Default
= 0.
Straight 2 of 5 IATA Message Length
Scan the barcodes below to change the message length. Refer to Message Length
Description (page 152) for additional information. Minimum and Maximum
lengths = 1-48. Minimum Default = 4, Maximum Default = 48.
Straight 2 of 5 IATA
Redundancy
To Next Page
Loading...
