114 Xenon XP User Guide
Good Read Tone - Output Sequences
The scanner may be programmed to either beep or click in response to a good read
of each barcode in an output sequence, or to emit a beep or error tone for a partial
sequence. Default = Good Read Click - Each Code in Sequence
and Error Tone -
Partial Sequence Output.
,
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple
symbols with a single pull of the scanner’s trigger. If you press and hold the trigger,
aiming the scanner at a series of symbols, it reads unique symbols once, beeping
and or vibrating (if turned on) for each read. The scanner attempts to find and
decode new symbols as long as the trigger is pulled. The maximum number of
barcodes read is 21. When this programming selection is turned Off, the scanner
will only read the symbol closest to the aiming beam. Default = Off.
Good Read Beep - Each
Code in Sequence
* Good Read Click - Each
Code in Sequence
Good Read Beep - Partial
Sequence Output
* Error Tone - Partial
Sequence Output
To Next Page
Loading...
