Xenon XP User Guide 233
Y - Vertical Barcode Offset
The vertical barcode offset allows you to offset the vertical center of the signature
capture area. Negative numbers indicate that the signature capture is above the
barcode, and positive numbers indicate that the area is below the barcode.
Measurements are in multiples of the minimum bar width.
Example: .
RF Default Imaging Device
The scanner supports imaging command processing (IMGSHP, IMGSNP, IMGBOX)
so that EZConfig for Scanning (see page 237) and other applications are able to
perform imaging functions as if they were communicating directly with a scanner.
To accomplish this, the scanner uses a menu command called RF_DID (RF Default
Imaging Device). RF_DID is the name of the scanner (BT_NAM) that is to receive
imaging commands. The default for RF_DID is “*”indicating that imaging
commands are to be sent to all associated scanners. Change this setting to
RF_DIDscanner_name to ensure that they are sent to a particular scanner. Refer to
"Page" on page 54 to generate a report containing the port, work group, scanner
name, and address for each scanner. Refer to "Scanner Name" on page 68 set a
unique name for each scanner.
Vertical Offset set to -7Y:
Vertical Offset set to 65Y:
To Next Page
Loading...
