Honeywell Xenon XP 1950g - Page 267

Xenon XP User Guide 249
RS232 Handshaking *RTS/CTS Off 232CTS0 37
Flow Control, No Timeout 232CTS1 37
Two-Direction Flow Control 232CTS2 37
Flow Control with Timeout 232CTS3 37
RS232 Timeout (1-5100
milliseconds)
232DEL#### 37
*XON/XOFF Off 232XON0 38
XON/XOFF On 232XON1 37
*ACK/NAK Off 232ACK0 38
ACK/NAK On 232ACK1 38
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 38
Packet Mode On 232PKT2 38
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 39
Bioptic ACK/NAK On 232NAK1 39
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout (1-30000
milliseconds) *5100
232DLK##### 39
Cordless System Operation
Replace a Linked Scanner Override locked Scanner (Single
Scanner)
BT_RPL1 42
Temporary Streaming Presentation
Mode
*Temporary Streaming
Presentation Mode On
BEPPGE2 46
*10 Second Timeout TRGTPM10000 46
30 Second Timeout TRGTPM30000 46
Presentation Mode in Base *Disabled BT_PIB0 46
Enabled BT_PIB1 46
Base Power Communication
Indicator
*On :*:BASRED1 50
Off :*:BASRED0 50
Low P owe r Ale rts
*Low Power Alert 10-30% LPIRAG0 51
Low Power Alert 10-50% LPIRAG1 51
Low Power Alert Flash Number (1-
9) *3
LPIFNO# 51
Interval Between Flashes (1-9) *2 LPIFDL# 51
Low Power Alert Repeat (1-5) *1 LPI_NO# 51
Interval Between Alerts (10-120)
*10
LPI_DL### 52
Low Power Alert Beep Off LPIBEP0 52
*Low Power Alert Beep On LPIBEP1 52
Reset Scanner Reset Scanner RESET_ 52
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page