7-2
Configuring IP Addressing
Overview
Configuring IP Addressing
Overview
This chapter describes the switch configuration features available in the menu
interface, CLI and web browser interface. For help on how to use these
interfaces, refer to:
■ Chapter 2, “Using the Menu Interface”
■ Chapter 3, “Using the Command Line Interface (CLI)”
■ Chapter 4, Using the HP Web Browser Interface”
Why Configure IP Addressing? In its factory default configuration, the
switch operates as a multiport learning bridge with network connectivity
provided by the ports on the switch. However, to enable specific management
access and control through your network, you will need IP addressing. (See
table 7-1 on page 7-10.)
To Next Page
Loading...
