HP 4108GL - CLI: Viewing and Configuring GVRP

14-39
Port-Based Virtual LANs (VLANs) and GVRP
GVRP
Port-Based Virtual LANs
(VLANs) and GVRP
CLI: Viewing and Configuring GVRP
GVRP Commands Used in This Section
Displaying the Switch’s Current GVRP Configuration. This command
shows whether GVRP is disabled, along with the current settings for the
maximum number of VLANs and the current Primary VLAN. (For more on the
last two parameters, see “Port-Based Virtual LANs (Static VLANs)” on page
14-4.)
Syntax: show gvrp Shows the current settings.
Figure 14-25. Example of “Show GVRP” Listing with GVRP Disabled
Figure 14-26. Example of Show GVRP Listing with GVRP Enabled
show gvrp below
gvrp page 14-40
unknown-vlans page 14-40
This example includes
non-default settings for
the Unknown VLAN field
for some ports.