11-19
Optimizing Port Usage Through Traffic Control and Port Trunking
Port Trunking
Ports: Traffic Control
and Trunking
This example uses a port list to specify only the switch ports an administrator
wants to view:
Figure 11-8. Example of a Show Trunk Listing for Specific Ports
The show trunk command in this example does not include a port list, and thus
shows static trunk group information for all switch ports.
Figure 11-9. Example of a Show Trunk Listing Without Specifying Ports
Listing Static LACP and Dynamic LACP Trunk Data. This command
lists data for only the LACP-configured ports.
Syntax: show lacp
To Next Page
Loading...
