HP 4108GL - Page 237

12-7
Configuring for Network Management Applications
Overview
Monitoring and Managing
the Switch
Listing Current Community Names and Values.
Listing Community Names. This command lists the data forcurrently con-
figured SNMP community names (along with trap receivers and the setting for
authentication traps — see “Trap Receivers and Authentication Traps” on
page 12-8).
Syntax: show snmp-server [<community-string>]
This example lists the data for all communities in a switch; that is, both the
default "public" community name and another community named "red-team"
Figure 12-3. Example of the SNMP Community Listing with Two Communities
To list the data for only one community, such as the "public" community, use
the above command with the community name included. For example:
HP4108# show snmp-server public
Configuring Identity Information. This command enables you to enter
contact-person and location data to help identify the switch.
snmp-server page 12-7
[contact <contact-str>] page 12-7
[location <location-str>] page 12-7
[community <community-str>] page 12-8
[host <community-str> <ip-addr>]
[<none | debug | all | not-info | critical>]
page 12-10
[enable traps <authentication> page 12-11
Default
Community and
Settings
Non-Default
Community and
Settings
Trap Receiver
Data (See page
12-8.)