HP 5120 series

134
Device Sensor Warnin
g
limit Alarmin
g
limit
S5120-28P-HPWR-SI
2 115 125
S5120-52P-SI 1 90 95
S5120-20P-SI/S5120-28P-SI 1 85 95
S5120-9P-SI 1 98 105
S5120-9P-PWR-SI
1 88 95
2 115 125
S5120-9P-HPWR-SI
1 75 90
2 115 125
• Clearing the 16-bit interface indexes not used in the current system
• Disabling password recovery capability
• Identifying and diagnosing pluggable transceivers
• Displaying and maintaining device management configuration
NOTE:
The confi
g
uration tasks in this document are independent. You can perform these tasks as needed in an
y
order.
Device management overview
The device management function allows you to view the current working state of a device, configure
running parameters, and perform daily device maintenance and management.
Configuring the device name
The device name is used to identify a device in a network. In the system, the device name is the same as
the prompt of the CLI. For example, if the device name is Sysname, the prompt of user view is
<Sysname>.
Follow these steps to configure the device name:
To do… Use the command… Remarks
Enter system view system-view —
Configure the device name sysname sysname
Optional
The device name is HP by default.
Configuring the system clock
Configuring the system clock
The system clock, displayed by system time stamp, is determined by the configured relative time, time
zone, and daylight saving time. To view the system clock, use the display clock command.