HP 5120 series User Manual

38
username and password on the remote authentication server. For more information about
authentication modes and parameters, see the Security Configuration Guide.
The following table lists telnet login configurations for different authentication modes.
Authentication
mode
Configuration Remarks
None Configure not to authenticate users
For more information, see
"Configuring none
authentication for telnet
login."
Password
Configure to authenticate users by using the local
password
For more information, see
"Configuring password
authentication for telnet
login."
Set the local password
Scheme
Configure the authentication scheme
For more information, see
"Configuring scheme
authentication for telnet
login."
Select an
authenticati
on scheme
Remote AAA
authentication
Configure a
RADIUS/HWTACAC
S scheme
Configure the AAA
scheme used by the
domain
Configure the
username and
password on the
AAA server
Local
authentication
Configure the
authentication
username and
password
Configure the AAA
scheme used by the
domain as local
Configuring none authentication for telnet login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see "Configuration requirements."
Configuration procedure
Follow these steps to configure none authentication for telnet login:
To do… Use the command…
Remarks
Enter system view system-view —

HP 5120 series Specifications

General

Brand	HP
Model	5120 series
Category	Switch
Language	English