HP 5120 series User Manual

30
Authenticat
ion mode
Configuration Remarks
Set the local password
"Configuring password
authentication for console
login."
Scheme
Configure the authentication scheme
For more information, see
"Configuring scheme
authentication for console
login."
Select an
authentication
scheme
Remote AAA
authentication
Configure a
RADIUS/HWTACAC
S scheme
Configure the AAA
scheme used by the
domain
Configure the
username and
password on the
AAA server
Local
authentication
Configure the
authentication
username and
password
Configure the AAA
scheme used by the
domain as local
NOTE:
A
newly confi
g
ured authentication mode does not take effect unless you exit and enter the CLI again.
Configuring none authentication for console login
NOTE:
This feature is not supported in FIPS mode.
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see "Configuration requirements."
Configuration procedure
Follow these steps to configure none authentication for console login:
To do… Use the command… Remarks
Enter system view system-view —
Enter AUX user interface view
user-interface aux first-number
[ last-number ]
—

HP 5120 series Specifications

General

Brand	HP
Model	5120 series
Category	Switch
Language	English