HP 5120 series

67
To do… Use the command… Remarks
Configure a password for the
local user
password { cipher | simple }
password
Required
By default, no password is configured for the
local user.
Specify the command level of
the local user
authorization-attribute level
level
Required
By default, no command level is configured for
the local user.
Specify the telnet service type
for the local user
service-type telnet
Required
By default, no service type is configured for
the local user.
Exit to system view quit —
Create a VLAN interface and
enter its view
interface vlan-interface
vlan-interface-id
Required
If the VLAN interface already exists, the
command enters its view.
Assign an IP address and
subnet mask to the VLAN
interface
ip address ip-address { mask
| mask-length }
Required
By default, no IP address is assigned to the
VLAN interface.
Displaying and maintaining web login
To do… Use the command… Remarks
Display information about web
users
display web users [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display HTTP state information
display ip http [ | { begin | exclude |
include } regular-expression ]
Available in any view
Not supported in FIPS
mode
Display HTTPS state information
display ip https [ | { begin | exclude |
include } regular-expression ]
Available in any view
Web login example
HTTP login example
NOTE:
This example is not supported in FIPS mode.
Network requirements
As shown in Figure 19, the PC is connected to the device over an IP network. The IP address of the Device
is 192.168.0.58/24.