HP 5120 SI Series

12
No. Attribute Descri
p
tion
8 Framed-IP-Address IP address to be configured for the user.
11 Filter-ID Name of the filter list.
12 Framed-MTU
Maximum transmission unit (MTU) for the data link between the user and NAS.
For example, with 802.1X EAP authentication, NAS uses this attribute to notify
the server of the MTU for EAP packets, so as to avoid oversized EAP packets.
14 Login-IP-Host IP address of the NAS interface that the user accesses.
15 Login-Service Type of the service that the user uses for login.
18 Reply-Message
Text to be displayed to the user, which can be used by the server to indicate, for
example, the reason of the authentication failure.
26 Vendor-Specific
Vendor specific attribute. A packet can contain one or more such proprietary
attributes, each of which can contain one or more sub-attributes.
27 Session-Timeout
Maximum duration of service to be provided to the user before termination of the
session.
28 Idle-Timeout Maximum idle time permitted for the user before termination of the session.
31 Calling-Station-Id
Identification of the user that the NAS sends to the server. With the LAN access
service provided by an HP device, this attribute carries the MAC address of the
user in the format HHHH-HHHH-HHHH.
32 NAS-Identifier Identification that the NAS uses for indicating itself.
40 Acct-Status-Type
Type of the Accounting-Request packet. Possible values are as follows:
• 1—Start
• 2—Stop
• 3—Interim-Update
• 4—Reset-Charge
• 7—Accounting-On (Defined in 3GPP, the 3rd Generation Partnership Project)
• 8—Accounting-Off (Defined in 3GPP)
• 9 to 14—Reserved for tunnel accounting
• 15—Reserved for failed
45 Acct-Authentic
Authentication method used by the user. Possible values are as follows:
• 1—RADIUS
• 2—Local
• 3—Remote
60 CHAP-Challenge
CHAP challenge generated by the NAS for MD5 calculation during CHAP
authentication.
61 NAS-Port-Type
Type of the physical port of the NAS that is authenticating the user. Possible
values are as follows:
• 15 — E t h e r n e t
• 16—Any type of ADSL
• 17—Cable (with cable for cable TV)
• 201—VLAN
• 202—ATM
If the port is an ATM or Ethernet one and VLANs are implemented on it, the value
of this attribute is 201.