254
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.1.40 255.255.255.0
[Switch-Vlan-interface1] quit
# Set the authentication mode for the user interfaces to AAA.
[Switch] user-interface vty 0 15
[Switch-ui-vty0-15] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Switch-ui-vty0-15] protocol inbound ssh
[Switch-ui-vty0-15] quit
# Create local user client001, and set the user command privilege level to 3
[Switch] local-user client001
[Switch-luser-client001] password simple aabbcc
[Switch-luser-client001] service-type ssh
[Switch-luser-client001] authorization-attribute level 3
[Switch-luser-client001] quit
# Specify the service type for user client001 as Stelnet, and the authentication method as password. This
step is optional.
[Switch] ssh user client001 service-type stelnet authentication-type password
2. Establish a connection between the SSH client and the SSH server
NOTE:
The device supports many types of SSH client software, such as PuTTY, and OpenSSH. The followin
is an
example of configuring SSH client using PuTTY Version 0.58.
# Establish a connection to the SSH server.
Launch PuTTY.exe to enter the following interface. In the Host Name or IP address text box, enter the IP
address of the server—192.168.1.40.
To Next Page
Loading...
