HP 5120 SI Series

86
[Device-vlan5] port gigabitethernet 1/0/3
[Device-vlan5] quit
4. Configure a RADIUS scheme.
# Configure RADIUS scheme 2000 and enter its view.
<Device> system-view
[Device] radius scheme 2000
# Specify primary and secondary authentication and accounting servers. Set the shared key to abc for
authentication and accounting packets.
[Device-radius-2000] primary authentication 10.11.1.1 1812
[Device-radius-2000] primary accounting 10.11.1.1 1813
[Device-radius-2000] key authentication abc
[Device-radius-2000] key accounting abc
# Exclude the ISP domain name from the username sent to the RADIUS server.
[Device-radius-2000] user-name-format without-domain
[Device-radius-2000] quit
5. Configure an ISP domain.
# Create ISP domain bbb and enter its view.
[Device] domaim bbb
# Apply RADIUS scheme 2000 to the ISP domain for authentication, authorization, and accounting.
[Device-isp-bbb] authentication lan-access radius-scheme 2000
[Device-isp-bbb] authorization lan-access radius-scheme 2000
[Device-isp-bbb] accounting lan-access radius-scheme 2000
[Device-isp-system] quit
6. Configure 802.1X
# Enable 802.1X globally.
[Device] dot1x
# Enable 802.1X for port GigabitEthernet 1/0/2.
[Device] interface gigabitethernet 1/0/2
[Device-GigabitEthernet1/0/2] dot1x
# Implement port-based access control on the port.
[Device-GigabitEthernet1/0/2] dot1x port-method portbased
# Set the port authorization mode to auto.
[Device-GigabitEthernet1/0/2] dot1x port-control auto
[Device-GigabitEthernet1/0/2] quit
# Set VLAN 10 as the 802.1X guest VLAN for port GigabitEthernet 1/0/2.
[Device] dot1x guest-vlan 10 interface gigabitethernet 1/0/2
Verifying the configuration
Use the display dot1x interface gigabitethernet 1/0/2 command to verify the 802.1X guest VLAN
configuration on GigabitEthernet 1/0/2. If no user passes authentication on the port within a specified
period of time, use the display vlan 10 command to verify whether GigabitEthernet 1/0/2 is assigned
to VLAN 10.
After a user passes authentication, you can use the display interface gigabitethernet 1/0/2 command to
verity that port GigabitEthernet 1/0/2 has been added to VLAN 5.