HP 54 Basic Cutter - Cut the Substrate; Change the origin; Extended load

NOTE: Although the OPOS sensor has been calibrated in the factory, HP recommends doing a test to determine
how well the factory-set parameters work with the materials you are using. If the accuracy is not satisfactory,
then do the OPOS calibration.
Change the origin
●
Press , , , or to change the origin.
The substrate moves to the new origin, and values appear on the screen. The X value is the distance from
the original origin; the Y value is the maximum cutting width.
●
Press to toggle the Y value between the maximum cutting width and distance from the original origin.
●
Press to toggle between the maximum cutting length and the distance from the original origin.
The X and/or Y value toggles.
●
Press if you have reached the desired origin.
The cutter comes online and is ready to receive data from the computer.
●
Or press to cancel.
The cutter moves to its original origin and comes online.
Extended load
The extended load function makes it possible to dene the limits of the Y axis so that the cutter can cut outside
the pinch rollers. Substrate has to be loaded before this function can be used.
1.
Press .
2.
Press . System setup appears on the screen. Press .
3.
Press > Actions. Press .
4.
Press or to scroll through the menu until you reach Extended load.
5.
Press or to dene the new limit at the right (origin). The head moves to its new origin.
6.
Press . Size appears on the screen.
7.
Press or to dene the new limit at the left.
8.
Press .
NOTE: Tracking is not guaranteed when using this mode.
ENWW Change the origin 27