HP 54 Basic Cutter - Specifications; Maximum working length; Front and rear margins; Side margins

HP 54 Basic Cutter
HP Latex 54 and 64 Cutters
Maximum working length 50 m (164 ft)
Front and rear margins 30 mm (1.2 in)
Side margins 25 mm (1.0 in)
Margin between prints (no cut-o) 30 mm (1.2 in)
Margin to cut o 30 mm (1.2 in)
HP 54 Basic Cutter, HP Latex 54 and 64 Cutters
Tracking performance Up to 8 m (26 ft) within guaranteed specications for substrates less than 762 mm (30 in) wide
Up to 4 m (13 ft) within guaranteed specications for substrates more than 762 mm (30 in) wide
Longer substrates can be handled, but then compliance with specications is not guaranteed
Thickness 0.05 to 0.25 mm (0.002 to 0.01 in) with standard knife
Up to 0.8 mm (0.03 in) with optional sandblast knife
NOTE: Tracking performance is not guaranteed in oversized mode.
Performance
This performance is achieved with wax-backed vinyl 0.05 mm (0.002 in) thick, total thickness not more than 0.25
mm (0.01 in).
Cut type Drag-knife with TurboCut and Tangential emulation modes
Cut width 135 cm (53.1 in) for the HP Latex 64 Cutter
158 cm (62.2 in) for the HP Latex 54 Cutter
Cut speed Up to 113 cm/s (44 in/s) diagonal
Up to 84 cm/s (33 in/s) for substrates wider than 736 mm (29 in)
Acceleration Up to 3 G diagonal
Up to 0.9 G for substrates wider than 736 mm (29 in)
Accuracy 0.2% of movement or 0.25 mm (0.01 in), whichever is greater
Repeatability ±0.1 mm (0.004 in)
Cut force 0 to 400 g of downforce, in 5 g steps
Cut thickness 0.05 to 0.25 mm (0.002 to 0.01 in)
0.8 mm (0.03 in) with optional sandblast blade
NOTE: The repeatability and accuracy specications are valid within the guaranteed tracking length (see
previous table), but not in oversized mode.
52 Chapter 9 Specications ENWW