Warnings and cautions
The following symbols are used in this manual to ensure the proper use of the cutter and to prevent the cutter
from being damaged. Follow the instructions marked with these symbols.
WARNING! Failure to follow the guidelines marked with this symbol could result in serious personal injury or
death.
CAUTION: Failure to follow the guidelines marked with this symbol could result in minor personal injury or
damage to the cutter.
Warning labels
Label Explanation
Hazardous moving part. Keep your ngers and other body parts
away from this area.
This label is located on the scan axis.
Fuse caution label. For continued protection against risk of re,
replace the fuse only with one of the same rating.
Double pole/Neutral fusing
This label is located near the power inlet, at the rear.
Caution: Always leave the pinch rollers in the upper positions when
the cutter is not in use.
This label is located on the side of the scan axis.
NOTE: The nal label position and size may vary slightly, but should always be visible and close to the potential
risk area.
Main cutter components
The following views of the cutter illustrate its main components.
ENWW Main cutter components 5
To Next Page
Loading...
Need help?
General
