HP 54 Basic Cutter - Main Menu; Tool; System setup; Actions

There are ve typical FlexCut parameters:
●
Full pressure: This parameter determines full pressure, used during FlexCut mode.
●
Full pressure cut length: This parameter determines the length that is cut with full pressure, usually the
length that will be cut all the way through.
●
Flex pressure cut length: This parameter determines the length that will be cut with reduced pressure or
without pressure. This is usually a much smaller value than the full pressure cut length: the length of the
substrate bridges.
●
FlexCut pressure: This parameter determines the pressure of the Flex pressure cut length. This is usually a
reduced pressure, so that the knife only scratches the substrate or cuts it only halfway through.
●
FlexCut velocity: FlexCut uses higher knife pressures. Higher knife pressures need lower cutting speed. With
this parameter the velocity of FlexCut can be set independently from the normal cutting velocity.
See Cut through on page 30 for more details.
Tool
How to change tools is explained in Set the tool type on page 50.
System setup
Press to access the remaining parameters and internal tests.
Actions
Condence test
The condence test performs a quick electrical and mechanical test of the cutter to make sure it is fully
operational. A sheet of substrate of at least A3/B size should be used for this test. The sheet is always cut on the
left side. Press
to start the test.
Load
This menu can be used when loading a substrate sheet. During loading, the maximum substrate length can be
set.
Extended load
This parameter is explained in Extended load on page 27.
Reset
The Reset instruction performs a complete reset of the cutter. Press to execute a reset.
ENWW System setup 35