HP 54 Basic Cutter - Main Menu; Pressure; Knife offset; Pounce gap

Main menu
Pressure
Pressure is preceded by its tool name. This parameter is explained in Set knife depth and pressure on page 18.
Knife oset
This parameter is explained in Change the drag knife oset on page 44.
Pounce gap
This parameter applies to an optional accessory.
The pouncing gap submenu is used to set or modify the distance between the pounced holes. The default
pouncing gap value is 1 mm.
After pressing , press or until the desired pouncing gap is displayed on the screen, then press
to conrm.
The value can be set between 1 mm and 50 mm.
FlexCut
FlexCut can be set to O, Fast, or Accurate. When the cutter is set to Fast or Accurate, it will alternately cut a
certain length with full pressure and a certain length with reduced pressure. The advantage of the FlexCut
feature is that it cuts completely through the substrate. Moreover, it also allows the material to stay together by
means of the small substrate bridges.
●
Fast is the quickest mode, but it is less precise due to the pressure changes during the cutting procedure.
●
Accurate is much slower, but much more precise because the cutter stops at every change of pressure.
34 Chapter 5 Detailed operation of the cutter ENWW